Walking Stick Tips Rubber Trekking Pole Tips Replacement Feet by BalonekCZ

BalonekCZ

Hobby & DIY>Sport & Outdoors

GIF

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 4 walls, 15% infill

Designer

36 min

1 plate

5.0(3)

0.2mm layer, 4 walls, 15% infill

59 min

1 plate

4.0(1)

Open in Bambu Studio

Boost

Released

Description

Replacement end cap for trekking poles. If you have a different diameter of the end of the stick just adjust the scale. Can be printed from any material . PLA , ASA , ABS , TPU

Comment & Rating (8)

@user_405805694

Print Profile

0.2mm layer, 4 walls, 15% infill

5 days of rough hiking in Hornstrandir and it held up super good. Note - I did use a lighter for 8 seconds then press fit around my specific walking stick for perfect fit.

@bozdincer

Print Profile

0.2mm layer, 4 walls, 15% infill

The designer has replied

@obrien3dprints

Boosted

Thanks for the make Bozdincer, any feedback I could use to improve?

@bozdincer

Replying to @obrien3dprints :

The design is very nice and I got the print nicely. However, it did not fit the tip completely. The inner diameter was a bit small.

@obrien3dprints

Boosted

Replying to @bozdincer :

Understandable! Since these are universal the diameter is designed to be too small. Another commenter held a lighter to the hole to soften it up, then press fit onto their pole. I'd give that a shot and see if that works