Background

I have a three striped mud turtle. The turtle loves to hide, outgrew a 3in clay pot, and needed more room. As a result, this small housing/dock was born. This housing/dock was inspired by all of the Pokemon related prints I've come across on this site.

Requirements/Specifications

• Build area of more than 170mm
• The dock is 169mm wide by 100mm deep x 100mm tall

Instructions

1. Print: a) PokeDock (housing) & b) PokeDock (roof & ramp)
2. Optional:
   • glue the housing to the roof & ramp
   • the dock is light and will initally float in water
     • to keep the dock from floating, place something like a rock to anchor it
3. Enjoy!

Print Settings

• layer height=.16 to .28 layer height
• 15% infill
• supports are only required for the roof & ramp (due to the curves)