Used for avoiding spring or motor-activated doors to fully close. I use this for my cat to open the door while leaving a tiny gap, to avoid the A/C wasting resources if the cat leaves the door fully opened. Can be used for doors with a width around 30-40 mm, depending on how flexible it is printed.

Printed on Ender 3 V2 with following settings:

• TPU 95A
• NO TOP LAYERS NOR BOTTOM LAYERS
• 2-3 walls
• Grid (or similar) infill, between 10-20% recommended
• 50% fan
• Around 30 mm/s speed
• 225º Hotend / 55º Bed