Low Poly Thinker Statue/Bust (3 Hours / No Supports)
Low Poly Thinker Statue/Bust (3 Hours / No Supports)
Boost
34
49
9
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
3 h
1 plate
Boost
34
49
9
0
49
35
Released
Description
This is an version of a ‘The Thinker’ statue that requires no support and prints in 3 hours on BBL's ‘standard’ speed profile.
Credit for the OG model goes to @LXO_STHLM on printables
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Almost perfect. The bridge under the right leg was too much to handle. the bridge settings for this profile could use a bit of tweaking. otherwise, pretty impressed.
The designer has replied
1
Reply
Interesting! Mine didn't have that. Either way it is definitely asking a lot; it'll likely come down to the adhesion properties of your filament. I believe that's the steepest overhang on the model.
Thank you very much for the feedback and the review!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
great model. only took 2 hours to print on the x1
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
vide très fragile
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld