IMPORTANT: This is just a model shell grip for a VR controller.

NOTE: This is for the Oculus Quest 1 controllers. If you are looking for the Quest 2 version, see here.

Introducing the "Chewey_GLK-17_Q1"!

For more details, please refer to the Quest 2 version's descriptions.
The picture is from the Quest 2 version, however, everything is the same except for the sizing of the hollow to fit the respective controller.

In addition to the reference models I noted in the Quest 2 posting, this Quest 1 model also uses the 3D scanned controller image posted by user aolshove on Thingiverse.

Each hand controller needs:

• 1x Grip
• 1x Slide
• 1x Front lower
• 2x Screws

Assembly notes:

• One screw is used to join the Grip with the Front lower. These were separated for ease of printing.
• One screw is used on the side to secure the Slide in place in case it slips off while mid VR session.

NOTE: The grip STL is for the RIGHT hand. Simply mirror it to print for the LEFT hand.

Derivatives and remixes are under Attribution-NonCommercial-ShareAlike, but please also include its original name "Chewey_GLK-17_Q1" somewhere on the final design. Please do not monetize on this model. Thanks!

Print instructions

Layer height: 0.2
Infill: 15%
Support: see "Suggested_print_orientagion_Chewey_GLK-17_Quest_1_set.3mf"

Refer to "Suggested_print_orientagion_Chewey_GLK-17_Quest_1_set.3mf" for print orientation and paint on support using PrusaSlicer.

The grip and front lower should be the same color.