This sponge holder can hold up to three typical sized dish sponge in a vertical orientation. The sponge holder measures 90mm wide and 130mm deep. Each sponge slot can accommodate 30mm thick sponge.
It is intended for use with an undermount designed sink. This is so the under side of the sponge holder can sit flat on the countertop with the lip overhanging the edge of the sink for draining water. See attached pictures.
The rails and dividers are printed separate and needs to be attached by inserting the rail pegs into the holes on the base. No support required on any piece.
Print 2 dividers and 2 side rails.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.