Search models, users, collections, and posts
modular roll stop
IP Report
Print Profile(1)
set of 4 beams - 0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
3
13
3
0
15
16
Released
Description
I made a modular roll stop, that doesn't use a lot of filament.
just 5gr per section of 15cm.
it consists of 3 parts:
- main beam
- connector
- holder (tape in place)
Just tape the holders where you want it to go an place the beam on top of it.
It works fine so far, it stays in place perfectly
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)