Hygrometer for P1S\P1P case
Copyright Claim
Hygrometer for P1S\P1P case
Boost
4
12
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
4
12
4
1
11
10
Released
Description
Support that allows you to install a hygrometer inside the P1S or P1P using the rear holes.
It is recommended to print in PETG or ABS, but PLA is also fine (tested).
The holes that are closed by the support do not affect the operation of the printer
Comment & Rating (4)
All
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
Just what I was looking for!
The designer has replied
1
Reply
Thanks for the feedback and the photo
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt sehr gut 👍
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld