Digital Vernier Caliper Replacement Battery Cover
Copyright Claim
Digital Vernier Caliper Replacement Battery Cover
Boost
9
12
4
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Boost
9
12
4
0
37
20
Released
Description
Digital Vernier Caliper Replacement Battery Cover
A replacement battery cover for common, generic, vernier calipers.
Prints on the face with the arrow on it, excellent bed adhesion is required as this is a small part.
Comment & Rating (4)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
A bit loose, but otherwise worked well.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I did have to up the print to 102% to get the cover to be a snug slip fit and not just fall off.
The designer has replied
0
Reply
Yeah, there are a few very similar variations I've found with these calipers which can make the fit vary. I've tried to find a middle ground. I might update the description to suggest your solution if people are finding the fit a little bit loose.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld