!IMPORTANT!************************************************************************!IMPORTANT!

Please print this with a raft or print slowly to avoid the small parts coming off the print bed. The nozzle may sometimes hit the components off.

Please do not upload this model anywhere else.

This is my first uploaded model! Please like if you enjoyed :)

Sorry for bad picture quality ;(

BUILDING STEPS

1: Glue the spring to the bigger hexagon plate with the pole sticking out of it. The spring should go no higher than the the pole.(Please wait for this to dry, I recommend using superglue but normal glue works fine once set.)

2: Glue the hexagon plate with the spring to the out ring of the ball bearing. This should be on the side where the triangle parts on the inside are flat with the piece.

3:Lastly, push the small hexagon plate into position(it should fit nicely and quite snug) and the model is finished! If you need to pop this parts off you can apply some pressure on the other side of the part.