This is a remix of the model made by Cartok, which can be found via the link below:

https://www.printables.com/model/559360-btt-adxl345-mount-with-creality-cr6-bed-mount-hole

I noticed my CR-6 Max had screw holes on the underside of the electrical connection to the bed and decided to remix this mount to fit on there! (I know this probably is not preferred, though with the silicone spacers, there wasn't really any other way to mount this…)

Print settings used:

• Material = PETG
• Temp = 225 degrees C
• Nozzle Size = 0.4mm
• Layer Height = 0.2mm
• Line Width = 0.4mm
• Build Plate Adhesion = Brim

Materials/Hardware Needed:

• 4x M3 screws: 2 for mounting to the electrical clip, and 2 for mounting the AXDL sensor
• 2x washers (for AXDL sensor)
• 2x M3 nut (for AXDL sensor)

STL and STEP files are included just in case!