Search models, users, collections, and posts
Zyn Container
IP Report
Print Profile(3)
V2- This one recommended , works with any layer height .0.08mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
Version 1, Version 2 below is designed with better threads 0.12mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
V2 Lid with AK on it, use 0.08mm layer, 2 walls, 15% infill for best results
Designer
4.5 h
2 plates
Open in Bambu Studio
Boost
50
179
26
14
466
316
Released
Description
Zyn Container with notches on the lid. I designed this because other designs either had issues with the lid screwing on, pulling apart easy or they were just not the style I was looking for. The Lid and the Bottom both are threaded and the threads on the lid has some extra clearance to ensure a good fit. I printed this with 0.12mm Line height, 2 wall loops and Gyroid infill.
Let me know if you run into any issues and I will get them fixed on my end. Thank you and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (26)