Zyn Container
Copyright Claim
Zyn Container
Boost
4
13
3
Print Profile(3)
V2- This one recommended , works with any layer height .0.08mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
V2 Lid with AK on it, use 0.08mm layer, 2 walls, 15% infill for best results
Designer
4.5 h
2 plates
Version 1, Version 2 below is designed with better threads 0.12mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
4
13
3
3
44
51
Released
Description
Zyn Container with notches on the lid. I designed this because other designs either had issues with the lid screwing on, pulling apart easy or they were just not the style I was looking for. The Lid and the Bottom both are threaded and the threads on the lid has some extra clearance to ensure a good fit. I printed this with 0.12mm Line height, 2 wall loops and Gyroid infill.
Let me know if you run into any issues and I will get them fixed on my end. Thank you and enjoy!
Comment & Rating (3)
All
Updated this container with bigger threads and external notches. I also added a lid for any AK fans, the blank lid is also uploaded. The top file is the original for anyone wanting more threads. The second file is the V2 with less threads and blank lid. The third file is just the v2 Lid with an AK on it.
(Edited)0
Reply
Print Profile
V2 Lid with AK on it, use 0.08mm layer, 2 walls, 15% infill for best results
0
Reply
Print Profile
V2- This one recommended , works with any layer height .0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld