IKEA SKADIS deburrer holder
Copyright Claim
IKEA SKADIS deburrer holder
Boost
7
17
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
7
17
5
0
33
20
Released
Description
Simple Ikea Skadis holder for a deburrer :)
- I used PLA, but any material should do
- 0.2 mm layer height
- supports needed
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
works great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👍🏼
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Okay, unfortunately has a bit too much play
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very wobbly on the board.
A tight fit would be much better.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld