This is a 3D Model for storing up to ten (10) GoPro Batteries (enduro or regular) and two (2) Dual Battery Charging Docks in the rear. Yes my business name is printed on the front. I designed it from scratch and would like credit if anyone does use it for themselves. Please no businesses (including YOUTUBE Channels) without reaching out to me first, my email is below. Any personal use is welcome. Allows for charging while in case with top on or off. Top can also act as a stand for the mics while charging or sitting on the table. If the RAW files are requested, I will clean them up and upload them.
Any comments, good or bad, are appreciated. Should print in under 3 hours and 35 minutes, with the following settings.
Any Color - Printed in PLA (Green Basic)
.28mm Extra Draft @BBL P1P
Quality|
Layer Height - 0.28 mm
Initial Layer Height - 0.2 mm
Seam Position - Back
Only one wall on top surfaces - Not applied
Only one wall on first layer - ‘unchecked’
Strength|
Walls loops - 2
Top surface pattern - Rectilinear
Top shell layers - 4
Top shell thickness - 1.12mm
Bottom surface pattern - Rectilinear
Bottom shell layers - 5
Bottom shell thickness - 2.24mm
Internal solid infill pattern - Rectilinear
Sparse infill density - 15%
Sparse infill pattern - Aligned Rectilinear
Support|
Enable support - ‘unchecked’
Type - n/a
Threshold angle - n/a
On build plate only - ‘unchecked’
Support/raft base - n/a
Support/raft interface - n/a
Others|
Skirt loops - 0
Skirt height - n/a
Brim type - No-brim
Brim width - n/a
Prime Tower - ‘unchecked’
Flush options - n/a
Print sequence - By later
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.