I had been needed a carrying case/storage case for my RODE Wireless GO II MIC sets, so I modeled and printed one up. It holds (left to right) one receiver and 2 mic packs. The top has a couple different functionalities, look at the pictures for specifics. Yes my business name is printed on the front. I designed it from scratch and would like credit if anyone does use it for themselves. Please no businesses (including YOUTUBE Channels) without reaching out to me first, my email is below. Any personal use is welcome. Allows for charging while in case with top on or off. Top can also act as a stand for the mics while charging or sitting on the table. If the RAW files are requested, I will clean them up and upload them.

Any comments, good or bad, are appreciated. Should print in under 2 hours, with the following settings.

Any Color - Printed in PLA (Black Basic)

.28mm Extra Draft @BBL P1P

Quality|

Layer Height - 0.28 mm

Initial Layer Height - 0.2 mm

Seam Position - Back

Only one wall on top surfaces - Top Surfaces

Only one wall on first layer - ‘unchecked’

Strength|

Walls loops - 1

Top surface pattern - Aligned Rectilinear

Top shell layers - 3

Top shell thickness - 0.28mm

Bottom surface pattern - Aligned Rectilinear

Bottom shell layers - 3

Bottom shell thickness - 0.28mm

Internal solid infill pattern - Aligned Rectilinear

Sparse infill density - 15%

Sparse infill pattern - Aligned Rectilinear

Support|

Enable support - ‘unchecked’

Type - n/a

Threshold angle - n/a

On build plate only - ‘unchecked’

Support/raft base - n/a

Support/raft interface - n/a

Others|

Skirt loops - 0

Skirt height - n/a

Brim type - No-brim

Brim width - n/a

Prime Tower - ‘unchecked’

Flush options - n/a

Print sequence - By later