Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
15
25
13
3
49
28
Released
Description
Had a request from a customer for a paw magnet. It has a spot on the back to flush mount a 15mm x 1.75mm magnet. I printed with supports so the magnet fit perfectly. Might not need to use supports. If you have any questions please let me know. Thanks!
Comment & Rating (13)
All
Downloaded but not multi-colour file, just one colour, very misleading and disappointing.
The designer has replied
0
Reply
It is setup for Bambu Slicer. If you open my print profile it is indeed multi color..
0
Reply
Replying to @CuhRazy
Ok I see that now, I downloaded the raw files, didn't realise but it won't let me change the colours unless I move the spools into the slots you have set it up to be, one thats hassle and 2 I can't use slot 2 at the moment as it has an issue
0
Reply
Replying to @tayden.lewis.cl
I don't think you understand. This doesn't need to be used in the slots that are setup in the slicer...
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ran out of filament so I couldn't finish but looked good
The designer has replied
0
Reply
Was there issues with the print? Why 3 stars can something be improved?
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
pretty good, I will print another one and try to figure out what layer you can pause this at and place your magnet so when it bridges over the magnet hole it doesn’t droop.
The designer has replied
0
Reply
Please share if you do! I just glued my magnet in place.
0
Reply
Boosted
sounds like a user error all his files work flawless
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld