This Card holder is able to carry up to two cards.
Printsettings for PLA:
Hotend:220°C
Bed:55°C
Infill:100%
Layer height:0,2mm
Support: Yes (tree-support recommended). The 3MF file contains the necessary supports
Brim:Yes
Note: I recommend to print the holder standing up (third picture), as this method provides the best printing results.
Your feedback and suggestions for design improvements are appreciated. Feel free to reach out with any ideas or improvements you may have.
-------------------------------------------------------------------------------------------------------------------------------------------------------
Update 08.03.2024
I uploaded a new version with rounded edges and just an overall rounder design, feel free to check it out!
--------------------------------------------------------------------------------------------------------------------------------------------------------
Update 19.04.2024
Some adjustments to make the Holder compatible with even more cards