Search models, users, collections, and posts
Simple Hanger
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
14
36
1
0
32
19
Released
Description
Simple hanger for sellotape/electrical tape or whatewer.
Two models presented. One very straight (no supports needed while printing) and other a bit lowered. Use the one fits you best. Here you will need to use a few supports.
On the photo I have a lowered one to fit small tape rolls in the middle of bigger ones. Hang area is 57.5mm long. Fits two standart electrical tape rolls.
You can Buy me a coffee if You feel good doing so :) (And very big Thank You For interest in my work)
https://www.buymeacoffee.com/warlogh
Comment & Rating (1)