I wanted a tiny cable tie anchor and could only find 1" ones here and people were suggesting to scale it for 0.75" adhesive tape, but it also scaled the hole for the cable tie making it unusable.
Three files, all the same height, all allow 4mm cable ties
Small: 0.5" pad
Med: 0.75" pad
Large: 1" pad
No support needed, bridges print fine on Prusa. See below for Bambu settings to bridge better. I think concentric Top Layer makes for a good look.
If using Bambu:
(I tested this before the 1.6.2.4 update which was supposed to fix Archane issues with bridges)
- Slow down Speed: Bridge: 20
- Increase Strength: Advanced: Infill/Wall overlap: 60%
Amazon Cable Ties:
https://a.co/d/27Hqk2p
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.