Voronoi Pot For Plants
Sibvilian
Shared by
Boost
21
42
5
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
2.6 h
1 plate
Open in Bambu Studio
Boost
21
42
5
0
54
40
Released
Comment & Rating (5)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
Printed almost perfectly the 1st time. I had a couple spots that did not connect properly but overall great print. For filament I used Bambu Desert Tan Matte.
(Edited)
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld