Starwars Star Destroyer Wall Art (hueforge)

you can scale to any size you want, but make sure you don't change the “Z” axis or it will throw off the color sequence.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Silver Transmission Distance: 2
PLA+ Sunlu Sky Blue Transmission Distance: 4
PLA+ Sunlu White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #16 (0.76mm) swap to Grey
At layer #27 (1.2mm) swap to Silver
At layer #31 (1.36mm) swap to Sky Blue
At layer #35 (1.52mm) swap to White for the rest.

please follow the settings in the bambu wiki seen below for best Results.

(1) Adjust the min layer height to 0.04 mm.

(2) Confirm specific process parameters