This set is a great statement piece! Although not intended for actual use, they are sized properly to meet standards for an M64 nut and M64x150 bolt (ISO4032 & ISO4762 respectively). I have also included the proper allen key (46mm) needed to install the bolt. The allen key has 3 main components, along with 2 pins to hold everything together:
Please see the assembly instructions below.
Print Settings
All pieces print fine without supports or any special settings. For best print results, print all pieces in the orientation as they come. Although not required, I reduced infill in most areas. However, I used a higher infill percentage below all top surfaces.
Allen Key Assembly
The following filament was used in the pictures above: