Pinecil/ TS100 CNC kitchen heat inserts rugged case
Remixed by
Copyright Claim
Pinecil/ TS100 CNC kitchen heat inserts rugged case
Remixed by
Boost
11
15
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.6 h
4 plates
Open in Bambu Studio
Boost
11
15
3
4
22
12
Released
Description
This is a remixed version that allows the pinecil and cnc kitchen heat inserts fit.
I would recommend printing at a 0.2mm layer height. 2 latches are needed. Printing the TPU seal isn't needed unless you want to water tighten the case. The latches and hinges are made to fit M3x20screws. CA glue can be used to fit the inserts and case halves together. However in my case the inserts fit the case so well, I didn't even need to glue the two together.
Comment & Rating (3)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
really nice case, close well. I wish the cheaper insert set I got would fit too, it didn’t. But that doesn’t mean the print didn’t come out really nice. and it’s a good place to store my iron.
only thing I found is the solder strand is a little loose and likes to drop out when I take out or put in my pinecil.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld