Big tree tech GTR and M5 case. 2 40mm fans.
I used a 90 degree usb to plug into the board. Can use the one it came with but you would have to remove one the plugs in the M5 board to get it to fit in the usb port.
Lid is little thick.. just make it thinner in the slicer.
Printer:
Hypercube evo 400x400
Rafts:
No
Supports:
Yes
Resolution:
0.20
Infill:
25%
Filament: Whatever PLA Black
Notes:
I used supports and other then needing a bigger printer to print this.. This is only V 1.0
No access to USB or SD unless you take the cover off. Would have to use the LCD for SD. I use octoprint.
Ps bottom is little thick.. will update the next day or two