This is for a m12 probe, I used it on the Ender 5 and you might have to bend the crimped belt fitting thing to the side to get the probe in or just cut a tiny bit off with your cutters.This will mount left of the hot-end,I had to mirror this to fit the ender 5 with out bumping.I will post the off sets latter

Config uploaded is for a Ender 5 (Stock Board), ABL, NO SD (i use octoprint) 2.0.5 Marlin.
Probe- LJ12A3-4-Z/BX
Blue- Ground - (Used Motherboard input power connector)
Brown- 12/24 + (Used Motherboard input power connector)
Black- Signal pin on z end stop

Hypercube Evo

No

20