This is a simple laptop stand where you can print it without any top and bottom layers and play with the infill patterns and density to produce cool different stands.

Also, you can increase or decrease the height of the model in the slicer, allowing to have only one piece holding the laptop or more than one.

It rises the laptop monitor about 16~17 cm (depending on the laptop).

I've printed with the following settings:

• Perimeters: 4
• Layer Height: 0.28
• Solid layers
  • Top: 0
  • Bottom: 0
• Infill density: 5% (You can choose the percentage based on the looking of it)
• Infill type: Honeycomb (Or the one you like the most)

Note: This was designed to fit perfectly on an Asus Pro 2440U although it can fit different brands and models.