Lightsaber Wall Mount with Jedi Logo
Boost
80
132
14
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
2.6 h
1 plate
Boost
80
132
14
1
105
104
Released
Description
Wall mount for most sized lightsabers including Savy's Workshop and Galaxy's Edge.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
design needs a little work but prints well. I suggest upping the top layers
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
beautiful
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
tres bonne qualité et solide
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
great model...strong enough to support Savi's saber with blade attached
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
printed very nicely a great addition for the wall sabers 😍
0
Reply
Thats a SUPER clean logo cut out, impressive to get the lines that crisp on the narrow sections.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Bed Adhesion Issue:Print profile did not work for me. Needed to add a brim to avoid warping. I suspect 100% infill on arms is contributing to this 90% should work just as good and avoid any over extrusion issues. Top quality setting is rectilinear which makes the top surface ugly, monotonic is much cleaner looking not sure why it was changed for this profile.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld