Michael Myers hueforge print - Halloween by ChainsawGraphics

ChainsawGraphics

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 1 walls, 100% infill

Designer

3 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

5 Color print.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Matte Mandarin Orange Transmission Distance: 2.6
PLA BambuLab Matte Dark Blue Transmission Distance: 1
PLA BambuLab Matte Scarlet Red Transmission Distance: 1.5
PLA BambuLab Matte Mandarin Orange Transmission Distance: 2.6
PLA BambuLab Matte Lemon Yellow Transmission Distance: 4
PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
Start with Mandarin Orange
At layer #5 (0.48mm) swap to Dark Blue
At layer #8 (0.72mm) swap to Scarlet Red
At layer #10 (0.88mm) swap to Mandarin Orange
At layer #13 (1.12mm) swap to Lemon Yellow
At layer #19 (1.6mm) swap to Ivory White for the rest.

Comment & Rating (4)

@user_4157601969

how many ams do i need i only got one and it has 5 colors any way around this?

The designer has replied

@ChainsawGraphic

what you can do, is reslice it to where the first color and last color are the same in the slicer, and same slot in the AMS. (It won’t look right in the slicer but it will print fine). Then after the first color fully prints,. pull that spool out of your AMS and insert the last color. It may pause due to not grabbing it fully,. but that’s not a problem. That’s the easiest way to do 5 and more color prints with only 1 AMS

@user_4157601969

Replying to @ChainsawGraphic :

awsome thanks!

@user_4157601969

Print Profile

0.08mm layer, 1 walls, 100% infill