Hygrometer Wall Mount for 41mm Hygrometer Thermometer
Copyright Claim
Hygrometer Wall Mount for 41mm Hygrometer Thermometer
Boost
12
24
3
Print Profile(1)
0.24mm layer, 2 walls, 9% infill
Designer
29 min
1 plate
Open in Bambu Studio
Boost
12
24
3
0
37
30
Released
Description
Whipped up a quick wall mount for the 41mm round hygrometer/thermometers you can find on Amazon. The others I found on Makerworld have it totally enclosed, but this one has open sides so it can be a bit more accurate to measure the surounding air.
Here is a link to some if you need: 41mm Hygrometer/Thermometer
- Fits 41mm Hygrometer/Thermometer
- Has three mounting holes that are 3.2mm in diameter. Only need to use one screw to mount it but I like having options so you can choose which hole(s) to use.
- No support needed. The main hole is shaped in a way that can print cleanly without support.
- MUST PRINT ON IT'S SIDE.
Comment & Rating (3)
All
Print Profile
0.24mm layer, 2 walls, 9% infill
I printed two for my daughters reptile enclosure. It was a little tight to push the hygrometer in, but it worked. Not sure how I will get them out when I need to change the battery.
0
Reply
Print Profile
0.24mm layer, 2 walls, 9% infill
Sehr schön
0
Reply
Print Profile
0.24mm layer, 2 walls, 9% infill
zu großes Loch.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld