Bag Clip
Copyright Claim
Bag Clip
Boost
5
7
6
Print Profile(2)
125% - 0.2mm layer, 2 walls, 15% infill
58 min
2 plates
0.2mm layer, 2 walls, 15% infill
41 min
2 plates
Open in Bambu Studio
Boost
5
7
6
4
16
11
Released
Description
I wanted a bag clip that needs only printed parts and that has a wide surface to properly seal the bag.
There is not a lot of options that meet this criteria, so i decided to design it myself. I hope that it can be useful for everyone else too.
I suggest to use PETG for the spring and PLA for the other part. But personally I used PLA for everything and it works perfectly
Print without support and i suggest 100% infill even if on the flat part of the clip is not necessary
Comment & Rating (6)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Awesome design!
1
Reply
Boosted
Print Profile
125% - 0.2mm layer, 2 walls, 15% infill
Great design. I like how everything snaps together. No loose parts. Very strong clamping force. Most 3D printed bag clips that I've printed had a very weak clamping force and usually fall off of the bag. Most also snap in half after a few uses. Printed using Sunlu Blue PETG and California Filament Fluorescent Orange PETG.
1
Reply
Print Profile
125% - 0.2mm layer, 2 walls, 15% infill
printed well, work great.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed nicely, like the larger one too!
1
Reply
Print Profile
125% - 0.2mm layer, 2 walls, 15% infill
1
Reply
Boosted
Print Profile
125% - 0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld