Multiboard tape measure holder
Copyright Claim
Multiboard tape measure holder
Boost
14
37
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
19 min
1 plate
Boost
14
37
4
0
63
25
Released
Description
This is a simple tape measure holder for multiboard that requires only 8g of PLA. Your individual printer tolerances may require that you scale up or down by a percentage point or two for a tight fit.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Other Issues:Peg is too short, falls out easily when removing tape measure
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld