Search models, users, collections, and posts
Simple AMS riser
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.8 h
2 plates
Open in Bambu Studio
Boost
7
9
0
0
8
4
Released
Description
I needed a quick solution to raise my 2nd ams unit off the desk. It raises the unit 100mm which allows me to move it around on the desk a little without putting to much strain on the cord and ptfe tube and power cord. It also gives the filament a straighter path to the printer. Just glue the 4 splices to the corner pieces and it is done.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)