FlexoMags

Create anything with FlexoMags. These flexible shapes unlock an entire imaginative world of creativity! The satisfying snap of the embedded magnets hold the pieces securely while allowing them to easily be pulled apart and re-positioned. Use over and over again to make creation after creation.

Recommend printing 5+ Plates of the primary shapes in order to have ample pieces to build with. Make sure to follow as more shapes and components will be released in the future.

PLA Tough+ has worked the best for this print as it has shown the best longevity. Basic PLA works good as well but it wears out quicker from the bending, flexing, and twisting. 

*Pause on Layer 20 to place the magnets*
No Supports (You may need to tweak your bridge settings to optimize this print for your printer)

REQUIRED: Magnets are 6mm x 2mm N35 Round Magnets. The N35 is important because weaker magnets do not have the holding power to make this work well. All magnets need to have the same orientation for this to work. 

I recommend using the Magnet Applicator from yopups to make it easier to insert the magnets and keep them all oriented the same direction. https://makerworld.com/en/models/1626190-magnet-applicator?from=search#profileId-1717015

Warning! Small magnets can be dangerous or deadly if ingested. Not recommended for ages 4 and under. Please discard toy if it becomes damaged or the magnet is no longer secured within the toy.