Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
41 min
1 plate
Boost
30
26
24
0
157
153
Released
Description
My own design of a thin and slim design of a phone case for Samsung S23+
Comment & Rating (24)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Actually works beautifully in PLA. Didn't use supports so had to cut off some around the charging port, buttons worked great. My gf loves it!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
some supports issues, but the case is very slim, won't protect much
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Hülle passt nicht.
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Too bad, the case fits great. Unfortunately, the place at the charging port is too thin and breaks again and again. At this point, the phone gets stuck somewhere (pull the phone out of the pocket) and then tears the case. So unfortunately not to use. Please revise then there is full score.
0
Reply
Passt leider nicht
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
fits good
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
top
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
works
0
Reply
no supports
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld