This camera mount can actually be used on almost any camera type. There are three parts to this mount. The Plug inserts into the end of the extrusion. The Bridge provides the offset and height. Then the "mount" can easily be modified to fit whatever camera you have.

An alternate mount is my: Another Camera Mount

Which is easier to print and uses the same "easily modified" mount.

Print Settings

Supports: No

Notes:

The Plug needs to be printed using supports. I typically put the "+" facing up.

The Bridge can be printed without supports, but I almost always have to print with Rafts to get it to print correctly.

The Mount needs to be printed using supports. I typically print it upside down.

Category: 3D Printer Accessories