Spool Holder holding up to large 3kg spools
Copyright Claim
Spool Holder holding up to large 3kg spools
Boost
64
98
40
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
4.7 h
2 plates
Boost
64
98
40
2
393
295
Released
Description
I wasn't happy with any of the spool holders out there that can take the bigger spools too - so here is my version! Max spool with: 11.5cm
This print uses PCS 608 Skateboard bearing, I got mine here: https://amzn.to/3r7NkKE (100 Pack) or here: https://amzn.to/3Sw0Cfj (50 Pack).
Note: Links are affiliate links, thanks for your support!
Comment & Rating (40)
All
Print Profile
0.2mm layer, 4 walls, 25% infill
Funktioniert 1A
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
good!
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
printed perfectly and very nicely. i used Ziro PLA HS Black. Roller works great, especially on the wider than normal RepRapper 3Kg spots which are 111mm and wouldn't fit on most other spool holders that only accommodate 105mm width. also, the reprapper had smallish ID spool hole of only about 35mm and doesn't fit some rod based holders where the dowel is too thick. this roller stand is perfect.
i printed some simple 608 PLA roller bearings and this is super smooth operation. thanks 👍🤗
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
Sinple and nice design
perfect for me
0
Reply
I redesign this spool holder to use the same roller and hold the spool in a standing configuration. It can be used with damaged spools which can not be used with the current “rolling” design. Here is a link for anyone interested: https://makerworld.com/en/u/523758224/verifying
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
Awesome printed great
(Edited)
0
Reply
The print profile is no longer public
Good print
The designer has replied
1
Reply
Thank you!
0
Reply
The print profile is no longer public
The designer has replied
0
Reply
Why?
0
Reply
Supports for spools didnt work. Fell over.
After manualy editing, great model
(Edited)0
Reply
Replying to @tkriesmair
Fair enough, though I had no problem printing it like this. Probably something to do with the filament.
0
Reply
Boosted
fits together nicely
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
its the only spool holder that i found that supports the large spool of mine and it works perfectly even if u go realy fast on a respooler
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (2)
Related Models
© 2024 MakerWorld