Gameboy Apple Watch Charging Stand
Gameboy Apple Watch Charging Stand
Boost
57
92
20
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.8 h
1 plate
0.2mm layer, 2 walls, 15% infill, 4 Color
18.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
2.8 h
1 plate
Boost
57
92
20
4
143
112
Released
Description
Makes your apple watch look like a gameboy when charging.
Print it upright, with supports as needed. Usually bridging does ok
Comment & Rating (20)
All
Boosted
Love it. I altered it slightly by extending the back and adding a slot for the straps to fit into in BambuStudio itself, as well as changing the print orientation so the buttons are face up so that less filament changes are required for the black/gray bits. Turned out great!
(Edited)
2
Reply
Buenas, podrías colgar el remix?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, 4 Color
Very fun print. I updated the colors slightly and printed on it's back with supports for the overhang. This cut down the printing time quite a bit (just over 2 hrs 30 min).
0
Reply
Kept the original design just added the original colors to it. Added the profile.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice print, Fits my 44mm watch perfect.
0
Reply
Boosted
I made it and loved it, but unfortunately I can’t use it because I have a cover on my watch. Is there anyway you could do one edited that moves it out three or 4 mm for people that have watch covers ?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Probably doesn't fit my 2020 model Watch SE. Too tight and the charging puck is smaller.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Chanel on the bottom could be bigger
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
my sister loves this!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld