I ain't got much left to lose, friend

If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full.  Send me a message if you have questions.

If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please.

If you do not have an AMS, just delete the filament changes and replace them with pauses instead. Then you can change filament manually when it pauses at the correct layer.

Important:

1. I have used a height range modifier in my print profiles for quicker printing. The layer swap numbers in the print profile will not match the ones written below in the print instructions. Do not worry about this.
2. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
3. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). 
4. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.
5. Please ensure your filament flow ratios are properly calibrated to get the best results.
6. You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm.

Remember to select the correct plate type for your printer.

Filaments Used:
PLA BambuLab Matte Charcoal  - Transmission Distance: 0.6
PLA BambuLab Basic Red  - Transmission Distance: 3.8
PLA BambuLab Basic Orange  - Transmission Distance: 4.4
PLA BambuLab Basic Yellow  - Transmission Distance: 5.5
 

Swap Instructions:
Start with Charcoal Black

At layer #26 (1.24mm) swap to Red
At layer #36 (1.64mm) swap to Orange
At layer #47 (2.08mm) swap to Yellow for the rest.