Sakura Bookmark Framed

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Two bookmarks similar in structure and shape, differentiating in foliage. One is more traditional bonsai with its vivid green foliage and the other a Sakura tree with its pink petal flowers.

This bookmark features a striking silhouette of a gnarled, dark tree trunk, intricately cut to reveal the book page beneath. The branches are adorned with a vibrant explosion of layered, textured magenta and pink cherry blossoms. 

More available - if not uploaded to MakerWorld, it will be on Patreon.

Sakura Bookmark

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Brown  Transmission Distance: 2.4 (or Orange)
    PLA BambuLab Basic Magenta  Transmission Distance: 3 (Pink or Red)
    PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer (0.96mm) swap to Brown (Or Orange)
    At layer (1.28mm) swap to Magenta (Pink or Red)
    At layer (1.52mm) swap to Jade White for the rest.
 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections