Door stop (Door holder)
Copyright Claim
Door stop (Door holder)
Boost
11
14
4
Print Profile(1)
Easy to remove supprts, 0.24mm layer, 4 walls, 15% infill
Designer
3.9 h
1 plate
Boost
11
14
4
0
68
32
Released
Description
Description
I was not truly satisfied with other door stops (Door holders) laying around so I designed this for my own household purposes.
This one is for a big gaps (like holding barn doors) but you can scale it up and down and it can be used in various applications.
Features
- Top surface has a wave grip to avoid slipping behind doors.
- Primary version is optimised for saving filament.
- Support-less version is optimised for printing speed but will require a bit more filament.
Recommended print settings
- Layer height: 0.2- 0.28mm
- Extrusion width: 0.4mm, forced
- Infill pecentage: 15-25%
- Infill type: grid, gyroid, honeycomb, triangle, or cubic (infill combination can be used as well if supported by slicer of your choice)
- Walls: 1 for top/bottom layers, 5 for all others
- Solid top/bottom layers: 5
- Supports: Download added print profile for primary version; no supports needed for support-less version
Documentation (1)
Bill of Materials (1)
Better Door Stop (Drawing).pdf
Comment & Rating (4)
All
I don't know if it would look as good but if you were to rotate the hexagons they wouldn't need supports ;)
0
Reply
True, by turning the angle of the hex they no longer needs support. Well spotted
1
Reply
Print Profile
Easy to remove supprts, 0.24mm layer, 4 walls, 15% infill
0
Reply
Print Profile
Easy to remove supprts, 0.24mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld