I took Adrian_CrimsonAzure 's and maker_guy 's sauce cupholder and stopped the print (Around layer 22 at .15) Then I printed out WoodAlanM 's Garmin Vent Clip. Superglued them together and Welded to make it extra secure with my dikale 3d doodler. Now the Sauce will be closer to m face!
Printer Brand:
Monoprice
Printer:
Maker Select
No
Supports:
No
.15
Infill:
holder50/clip100
Sand pieces and Super Glue together. You can take a hair dryer and heat up sauce holder a little if you want to change angle of where clip mounts to it. After glue sets, I ran a bead to secure parts with my 3D Doodler. May not be necessary. May want an anneal PLA if you plan to leave part in the hot car in the sun.
Category: Kitchen & Dining