I really like and appreciate this model. I put a light inside and noticed the infill pattern is visible when illuminiated. Would using 100% infill for the logos eliminate seeing the infill pattern? I found the wire openings to be too small to get a USB connector through, which means having to desolder and then resolder the connector to the light strip to get it to fit through the hole. Also, passing the wire through the mounting bracket prevents the bracket from sitting flush against the wall, making it unmountable. If I could offer suggestions, I would hope the wire opening could move to the frame and be big enough for a USB A connector. The mounting bracket could also benefit from being wider and having screw holes. Does the mounting bracket need to be glued? It seems a bit loose, allowing the sign to sag and I’m not sure how to tighten that up. These are just my respectful opinions. Thank you for sharing.