Wall mount for 64mm inline skates. Designed to fit on a 2.5 inch board, but could be mounted on anything using the provided screw holes. Very strong - likely overbuilt.

Fits both pairs of 64mm skates that currently live wherever I need to step.

If your printer is 220x220, shave 2.5mm off either end in your slicer. They definitely don't need to be as thick as they are. If you care about aesthetics, you could also block out the 4 screw holes in the middle as they're mostly for flexibility in mounting.

I print mostly in PETG, but this should work in PLA too, unless you're skating with built-in ankle weights.