No Print Profile yet. Add one to earn points.
I made this design for the Christmas Prusa Contest, but I didn't make it in time. Anyway, I still would like to share it, I hope you like it.
This is a multicolor print using 5 filaments printable in almost any printer applying the Z HOP command technique in the Slicer software.
The files: Jesus, Star, Maria&Jose and Manger (print in this order) are made at Z=0,6 mm (3 layers at 0,2 mm height), and the base; the last one, Base, has 4 mm height. Take this in consideration when slicing all the models.
I made the GCODE for my Ender 3 and if you want to use them, you should use the gcode files in the following order:
In every case, you must remove the skirt and print the next file without removing the previous one.
I used colors for the files names, because it is easier to use remember them while printing, but you might use any colors you like.