Make a DIY Moonlamp with this stl. Simply add a thin lightbulb to light it up. the hole in the bottom should fit an e14 socket.
find full instructions here: https://daniel-strohbach.de/diy-mondlampe
- Layer Height: 0.2 mm
- Top/Bottom Pattern: Concentric
- Bottom Pattern Initial Layer: Lines
- Infill: 100%
- Support Placement: Touching Buildplate
- Support Overhang: 80°
- Support Pattern: Triangles
- Support Z Distance: 0.3 mm
- Support X/Y Distance: 1 mm
- Enable Support Interface: Yes
- Build Plate Adhesion Type: Raft
- Raft Air Gap: 0.3 mm
- Initial Layer Z Overlap: 0.1 mm
- Raft Top Layers: 3