35mm double door hook
Copyright Claim
35mm double door hook
Boost
1
1
4
Print Profile(1)
0.2mm layer, 3 walls, 5 top/bottom concentric shells, 16% infill
Designer
25 min
1 plate
Open in Bambu Studio
Boost
1
1
4
0
8
6
Released
Description
Strong yet simple design.
It is curved to add extra strength, the top/bottom printed in a concentric pattern, and the internal infill set to rectilinear to bond the layers better.
It takes about 4m(12g) of filament, and I recommend using PETG as it should deal better with constant load.
The internal gap measures 35,2mm so it should fit 35mm doors.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 3 walls, 5 top/bottom concentric shells, 16% infill
So far so good!
The designer has replied
0
Reply
Thanks! Hope it will last a bit more than last one :D
0
Reply
Printed two of these in Translucent PETG and they came out nicely. Going to test them on a few doors in the house, but so far so good, thanks!
1
Reply
Print Profile
0.2mm layer, 3 walls, 5 top/bottom concentric shells, 16% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld