Bambu Lab X1C P1P Spoiler / Chamber Waste recovery for debris removal
Remixed by
Copyright Claim
Bambu Lab X1C P1P Spoiler / Chamber Waste recovery for debris removal
Remixed by
Boost
19
39
12
Print Profile(1)
0.12mm layer, 2 walls, 30% infill
Designer
1.9 h
1 plate
Boost
19
39
12
0
120
96
Released
Description
A simple print that forms a ramp at the front of your Bambu X1C making it easier to scoop out any stray bits of plastic.
Some modifications to original design :
- Only One part instead of two (rotate it at -45° on bambu plate for print) => easier to print
- recover ledge to prevent waste from falling between piece and ledge
- greater slope to facilitate extraction of wastes
Need supports, brim about 2mm to prevent wrap. About 1h30 with adaptative layer height
Comment & Rating (12)
All
Print Profile
0.12mm layer, 2 walls, 30% infill
printed well enough in ASA, but doesn’t sit totally flush against the bottom of the printer. Also one of the hooks broke off while removing the supports.
0
Reply
Could be ASA shrinkage?
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
5*
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
this you need
(Edited)0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
Tut was es soll und ich konnte hier auchmal Stützstrukturen testen. Danke dafür.
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
My first print with supports. Came out perfect, easy to remove(just be careful on the ends), and fit perfectly.
0
Reply
Printed in ABS and came out perfect! Thanks, very well done part.
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
0
Reply
Related Models
© 2024 MakerWorld