I have made an adjustable MagSafe stand for the new range of iPhones!

I previously made a stand that didn't move (https://www.thingiverse.com/thing:4661361) but wanted something that I was able to adjust the angle on.

This model is made up of 5 parts and requires 2 M4 Nuts and 2 M4 10mm Screws to secure the arm and the ball. Both the Arm and Ball models have insets for the M4 Nuts.

The Base also has 4 spots to put small rubber feet to help with slipping.

The Back has a small cable route but happy for people to try and make this work better. I like having the extra grip as it helps when adjusting the angle.

Found that the whole ball joint works a lot better if you add some melted wax to the inside of the joint.

Always open to any suggestions or improvements!