Catan Card Holder by amithacoon

amithacoon

Toys & Games>Board Games

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

for 68x44 cards - 0.2mm layer, 2 walls, 15% infill

3.2 h

1 plate

4.8(5)

80mm x 55mm Cards, 0.2mm layer, 2 walls, 10% infill

4.5 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

111

121

Released

Description

catan card holder. really nice to play with

Comment & Rating (11)

@Bozosdad

Print Profile

for 68x44 cards - 0.2mm layer, 2 walls, 15% infill

This model is 20% too small for 55mm wide Catan cards. Make sure to scale to 120%. Otherwise love the design.

The designer has replied

@mars3142

You‘re right. I didn’t created it for the larger cards. It’s only for the current card size, but the original creator has both sizes as STLs.

@Bozosdad

Replying to @mars3142 :

I see. Might be useful to note in the descriptions the card size this design is intended. Love the model design and thanks for sharing it.

@mars3142

Replying to @Bozosdad :

Updated the title of the print profile to reflect the card size. Good advice. Thanks.

(Edited)

@BigBadBrew

Print Profile

for 68x44 cards - 0.2mm layer, 2 walls, 15% infill

printed ar 120%

@Bozosdad

This model is just what i was looking for to hold my Catan cards for my new 3D printed board. I printed it and soon realized the model was scaled too small for the Catan cards. After some measurements of the actual cards and the openings on the printed model I found the model to be 20% too small. Reprinted at 120% and it is now the perfect size for the cards.